Ford Escape Automobiles Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,283 Posts
Discussion Starter · #1 ·
i just need to know if i require a special puller for the pulley, or will my 2 or 3 jaw puller work? but if your so inclined for the non mechanics, feel free to do your wonderful step by steps!. after all the work i did today, i still have a front main to replace, and the rear wiper motor. i have already taken it out once, but if there is not a fancy write up that might be helpful. and one of these days i will replace my broken coil lol. (it works just the plastice piece that the bolt goes through is broken, so its zap strapped in place. i should fix it before :fan:
 

·
Premium Member
Joined
·
12,182 Posts
How about a little JB Weld on that coil? Do you care what it looks like? I don't think that the epoxy is conductive, but you might check if you decide to use it. ;)
 
1 - 2 of 2 Posts
Top