Ford Escape Automobiles Forum banner

2008-2009 Liftgate Molding removal and installation

585 Views 0 Replies 1 Participant Last post by  jpark


Removal and installation

1) Remove the liftgate trim panel.

2) Disconnect the license plate housing electrical connector.

3) Remove the license plate housing retaining nuts (4 required).

4) Release the license plate housing from the push clips and remove the license plate housing from the liftgate.

5) To install, reverse the removal procedure.
See less See more
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top