Cruise control cable

790 Views 3 Replies 4 Participants Last post by LEO_Escape, Jan 23, 2011

coldbear

Discussion Starter · Jan 20, 2011

My cable continues to jump off the TB pully. Any suggestion on how to keep it on??

Save

1 - 1 of 4 Posts

LEO_Escape

· #4 · Jan 23, 2011

OldYeller said:
My does the same...I used a small plastic tie strap around the connector where the slot is that slides off and then wrapped a thin (1/8th inch) piece of electrical tape around that to keep it in place. So far...works well. :thumb:

Bingo! I used a zip tie on me and it's held up for a couple months now. I do imagine though that after a while, the hot and cold cycles will take their toll on it and make it brittle and snap one day. But for the tiny cost of a new zip tie, I'm fine with that.

Save

1 - 1 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.