Ford Escape Automobiles Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
758 Posts
I have a 05 Escape hybrid and it is not an issue to do what you are asking to do. Run the electrical wiring off the fuse box located on the passenger side of the center console. I have the Helms book and let me look at it and I will post some more information later tonight.
 

· Registered
Joined
·
758 Posts
Link to remove the center console:

viewtopic.php?f=28&t=20

by Squishy - Sun Mar 02, 2008 8:47 pm

FLOOR CONSOLE

Removal and Installation

All Vehicles
1. Position the seats forward and remove the 2 rear bolts.
2. Position the seats rearward and disconnect the battery.
3. Position the parking brake handle to the full-up position.
4. Remove the transmission selector lever bezel.
5. Release the parking brake handle boot from the floor console finish panel.

Mariner
6. Remove the floor console top panel.

All Vehicles
7. NOTE: On Escape, if removing the floor console storage bin, squeeze the front and rear of the storage bin to release the retaining tabs from the floor console finish panel.
-Remove the floor console finish panel.
-Disconnect the electrical connectors.

8. Remove the 6 bolts and remove the floor console.
9. To install, reverse the removal procedure.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top