Ford Escape Automobiles Forum banner

ESCAPE HEADLIGHTS

3K views 8 replies 5 participants last post by  andjayik 
RedRaptor said:
I'll be putting HIDs into our 2010 Escape very soon. Its good to hear that the stock cutoff is decent enough as we drive up to our cottage at night and don't want to blind oncoming traffic.

Jeff: When you installed your HIDs, did you remove the headlight housing from the car? It looks its held in by 3 bolts (two on top and one near the bottom). I figure it might be easier than cutting up your hands.
There are four bolts on each headlamp housing. You need to remove the front bumper cover to access the two bolts on the lower section of each headlamp, especially the one toward the back.

And that applies to all 2001-2004, 2005-2007, and 2008-? North American E/M/Ts.
 
Exactly, but my point was that you DO need to remove the bumper cover if you want to remove the headlamp housings.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top